English
Categories
- PNP/Go Fly Accessories
- Kit Accessories
- HSD Jets
- PowerBox
- Carbon Fiber
- Air Systems
- Accessories
- Installation Organizers
- Building Materials
- Finishing Materials
- Adhesives
- Electric VioFan (EVF)
- Chargers / Power Supplies
- Electric Accessories
- Batteries
- Turbine Mounts & Straps
- Turbine Accessories
- Fuel Cells
- Fuel System Accessories
- Jersey Modeler
- Cockpits
- Lubricants
- PermaGrit
- Tools
- Radio Gear
- Pilots
- Landing Gear
- Wheels Tires and Brakes
- Jet Cases / Cradles
- Specials
- Apparel and Gifts
- Books
- Gift Certificates
- Penn Bags
Featured [more]
UAT - Ultimate Air Trap
UAT Mount
3/16" dia. 1-1/2" long axles for BVM Duro-Struts
3/16" dia. 1-1/2" long axles for BVM Duro-Struts, precision ground stainless steel Includes nylon washers and E clips
$10.00
3/16" dia. Axles for 3/16" Wire Struts, precision ground and pla
3/16" dia. Axles for 3/16" Wire Struts, precision ground and plated Includes nylon washers and E clips
$13.50
3/16" dia. axles for 5/32" wire struts, precision ground and pla
3/16" dia. axles for 5/32" wire struts, precision ground and plated Includes nylon washers and E clips
$13.50
35mm Door Cylinder
35mm Door Cylinder USED IN: BVM F-16 1:6 scale PNP Nose Gear Door BVM YAK130 1:4 PNP Main Gear Door BVM F-18 1:5.5 PNP Main Gear Door
$32.99
4" (F-100 Main) Tire Change Cone
BVM's Tire Change Cone assists in changing the BVM Solid Rubber Tires.
After removing the old tire from the rim. Insert the cone tool into the axle bushing of the rim. Place the tire over the cone. Place the Wooden Push Tool over the tire. Slowly push straigth down, keeping fingers clear from the underside. For larger wheels, it may be nesessary to place the wheel on the floor and stand on the push tool.
$16.50
4" MAIN WHEEL BRAKE O'RING
4" MAIN WHEEL BRAKE O'RING USED WITH: MiG-15, BVM F-16 1:6, BVM Cougar, BVM L-39, BVM F-18 1:7.75, F-86 1:5
$1.75
4" Tire (MiG-15)
BVM's Solid Replacement Rubber Tire
4" Tire MiG-15
BVM offers Tire Change Tools to help assist in changing your BVM Tires. It's so easy you can even change a tire at the flying field. BVM has several different jet wheel sizes and provides the tools to match each one. There are the Tire Change Cone and Wooden Push Tool. The Wooden Push Tool is specifically designed to work with more than 1 size cone - refer to the product description for the correct Push Tool.
$22.50
4-1/16 Tire
BVM's Solid Replacement Rubber Tire
4-1/16" Tire for F-100, F86(80), and Ultra Bandit.
BVM offers Tire Change Tools to help assist in changing your BVM Tires. It's so easy you can even change a tire at the flying field. BVM has several different jet wheel sizes and provides the tools to match each one. There are the Tire Change Cone and Wooden Push Tool. The Wooden Push Tool is specifically designed to work with more than 1 size cone - refer to the product description for the correct Push Tool.
$35.00
4-1/16" Main Wheel - Aluminum
4-1/16" Main Wheel - Aluminum Ultra Bandit Weight 7.26 oz • Width 1"
$93.50
4-1/4" Replacement Tire
4-1/4" Replacement Rubber Tire
NON-SOLID TIRE - Used with BVM Go Fly Gold Models: F-16 1:6, Cougar, F-1, F-18F, YAK 1:4, L39 and Renegade
$30.00
4-3/4" Replacement Tire
4-3/4" Replacement Rubber Tire
NON-SOLID TIRE - Used with BVM Go Fly Gold Models: F-18 5.5, YAK 1:4.85
$35.00
5MM PNP Wheel Bushing
5MM PNP Wheel Bushing
6MM PNP Wheel Bushing
6MM PNP WHEEL BUSHING
Allen Wrench Set, METRIC - 4pcs
ENGRAVED Allen Wrench Set Purple 4pcs Titanium Coated Tips
~FREE PERSONALIZED ENGRAVING ON THE TOOLS~
Take the guess work out of who's tool it is. 4 Piece Set Includes: HEX 1.5 X 180mm HEX 2.0 X 180mm HEX 2.5 X 180mm HEX 3.0 X 180mm
** Please note that the personalized custom engraved tools are made per order and the turn around time frame is about 4 - 6 weeks.
$24.99
Allen Wrench Set, METRIC - 4pcs
Allen Wrench Set Purple 4pcs Titanium Coated Tips 4 Piece Set Includes: HEX 1.5 X 180mm HEX 2.0 X 180mm HEX 2.5 X 180mm HEX 3.0 X 180mm ** Please note this item is not personally engraved and will only have the BVM Logo and Tool Size.
$24.99
Allen Wrench Set, SAE (Inch), 4pcs
ENGRAVED Allen Wrench Set Purple 4pcs Titanium Coated Tips
~FREE PERSONALIZED ENGRAVING ON THE TOOLS~
Take the guess work out of who's tool it is. 4 Piece Set Includes: HEX .050 X 180mm HEX .063 X 180mm HEX .078 X 180mm HEX .093 X 180mm
** Please note that the personalized custom engraved tools are made per order and the turn around time frame is about 4 - 6 weeks.
$24.99
Allen Wrench Set, SAE (Inch), 4pcs
Allen Wrench Set Purple 4pcs Titanium Coated Tips 4 Piece Set Includes: HEX .050 X 180mm HEX .063 X 180mm HEX .078 X 180mm HEX .093 X 180mm ** Please note this item is not personally engraved and will only have the BVM Logo and Tool Size.
$24.99
Aluminum Air Disconnects 6/PK
Aluminum Air Disconnects 6/PK
Airline Disconnects will support 2MM or 3MM airline with included 3MM fittings.
$28.50
Aluminum Nose Gear Flex Arms - F-16/F-86 (pair)
Aluminum Nose Gear Flex Arms - F-16/ F-86 (pair) **LIMITED QUANTITY REMAINING**
$33.00
Anti-Static Fuel Additive
Static Electricity Build-up and Discharge in your turbine powered model. The effect of static electricity build-up and discharge is a problem associated with large capacity fuel systems in low humidity conditions. The electro-static charge is caused by the relative motion of two non-conductive materials such as fuel flowing through tubing, or fuel sloshing in an epoxy/Kevlar or plastic tank. The charge accumulation is greatly enabled by the lack of moisture in the air. The large fuel tanks and more powerful fuel pumping systems can accumulate 20,000+ volts. The discharge event can, and has on occasions, disabled the engine E.C.U. and even the R/C receiver. BVM's first confirmed experience with this phenomena was with the prototype Ultra Bandit on an unusually dry day in October '05. The discharge occurred as the wheels left the ground. We had to repair the model. Since low humidity is a rarity in Florida, it took us awhile to identify the problem and address the solution. The simple solution is this fuel additive. Just add 2 cap full's per 5 gal. mix of Jet A, Kerosene, or Diesel fuel.
$13.95
Assorted Plug
BVM Aluminum Plugs fit our 6mm OD (4mm ID, 5/32") Line. These can be used for Smoke or Fuel Lines. The Aluminum Plug is used after fueling your aircraft. Now available in Purple and Silver to easily identify if it is a fuel or smoke line. Includes: 1 Purple and 1 Silver Plug
$5.99
Bandit ARF MKII Kevlar Hopper Tank
Bandit ARF MKII Kevlar Hopper Tank for increased fuel capacity. 34oz *Please Note fuel systems are manufactured per order. Please allow 2 weeks for processing.
$155.00
Bandit ARF Nose Gear Flex Arms - pr
Bandit ARF Nose Gear Flex Arms - pair
Bandit Clear Canopy & Cockpit
For All Bandits
Bandit EVO Main Flex Plates
Bandit EVO Main Flex Plates
OLD STYLE
PACKAGE INCLUDES:
2 - CF PLATES
12 - M3.5 X 16 TRUSS HEAD SCREW
BobCat Jet-Foam Cradle Insert
BobCat Jet-Foam Cradle Insert
BVM 2020 T-Shirt White - Small
BVM 2020 T-Shirt White - Small
Gildan 50% Cotton / 50% Polyester
**BRAND NEW - IN ORIGINAL PACKAGE. JUST CLEARING OUT OLD INVENTORY**
$25.00
BVM Air Inflator Adaptor
BVM has a simple solution for filling pneumatic air tanks. Simply take this adaptor out of the package and attach to your air inflator and you are ready to go. You no longer need to fuss with safety wire or zip ties to hold the airline in place. The BVM Inflator Adaptor includes 6 inches of the BVM Heavy Duty Airline. *This adaptor is not designed to retain pressure* **This is NOT a BVM Air Fill Valve. To order a BVM Air Fill Valve use part number BVM5758**
$19.99
BVM Black Snapback Hat
Update your headware collection with this new BVM Snapback Trucker Hat. These Richardson Trucker Hats are known for its quality and fit.
Six-panel construction delivers the classic look and feel
Premium materials and craftsmanship ensure an ideal fit for all sizes
Standard cotton sweatband provides comfort for all-day wear
PRODUCT SPECIFICATIONS
STYLE: 6 Panel
PROFILE: Mid Pro
BILL: Precurved
SWEATBAND: Standard
FABRIC: Cotton-Polyester Twill/Trucker Mesh
COMPOSITION:
Front: 60% Cotton/40% Polyester
Back: 100% Polyester
CLOSURE: Snapback
BVM Clear Strut Damping Grease, 10cc
BVM Clear Strut Damping Grease, 10cc USED IN BVM PNP STRUTS
$4.95
BVM Collar Tool
The 2mm airline system works well in the PNP jets. Applying the tubing to the small metal barbed fittings can be tedious and some breakage of the fittings has occurred.
BVM E-Brake Valve
Proportional Control - No Air Supply System Required The BVM E-Brake will operate all BVM "O" Ring Brakes. It provides complete proportional control and foes not require any storage tanks or associated valves, filler fittings, etc. It will fit into your model in the same space / volume as does a medium size air storage tank. This new Version 4 BVM E-Brake is a larger diameter cylinder. This provides more volume for braking power. Some assembly is required. NOTE: The E-Brake V4 kit does not include the Servo. BVM recommends the Savox 227 servo to operate the E-Brake V4.
$85.00
BVM F-1 Mirage Clear Glass Canopy
BVM F-1 Mirage Clear Glass Canopy Disclosures: BVM prides itself in providing a quality product delivered to customers on time. Due to the popularity of certain products, we can not guarantee that each item you have ordered will be in stock. If any items you ordered are not in stock, BVM will inform you immediately. If you need an expedited order, please call BVM to verify the stock BEFORE placing the order.
$65.00
BVM F-16 1:5 After Burner Ring
BVM F-16 1:5 After Burner Ring Disclosures: BVM prides itself in providing a quality product delivered to customers on time. Due to the popularity of certain products, we can not guarantee that each item you have ordered will be in stock. If any items you ordered are not in stock, BVM will inform you immediately. If you need an expedited order, please call BVM to verify the stock BEFORE placing the order.
$25.00